砌体结构工程施工方案编制指南 (加气块) 插入项目效果图 工程名称: 文件编号:CSCEC5-FAZN-23(项目自拟编号)项目自拟编号) 发布日期: 执行日期: [工程名称] 砌体结构工程施工方案(项目自拟编号)加气 块) 目 录 一、编制说明···································································1 1.1 编制依据·········································································1 1.2 编制人员·········································································1 1.3 发放范围·········································································1 二、工程概况···································································2 2.1 工程概况·········································································2 2.2 设计简介·········································································2 三、施工部署···································································3 3.1 组织机构·········································································3 3.2 工程施工条件···································································3 3.3 施工准备·········································································4 3.3 施工安排·········································································5 四、施工计划···································································7 4.1 施工进度计划···································································7 4.2 资源配置计划···································································7 五、深化设计···································································9 5.1 二次结构深化设计·····························································9 5.2 砌体排版深化设计···························································11 六、施工工艺技术····························································13 6.1 工艺流程·······································································13 6.2 施工方法·······································································13 七、验收要求·································································17 7.1 验收内容及验收标准························································17 7.2 验收程序及人员······························································19 八、管理及保证措施··························································20 I [工程名称] 砌体结构工程施工方案(项目自拟编号)加气 块) 8.1 质量保证措施·································································20 8.2 安全文明施工措施···························································23 8.3 环境、职业健康安全管理保证措施·····································24 8.4 进度施工措施·································································25 九、相关施工图纸····························································26 II [工程名称] 砌体结构工程施工方案(项目自拟编号)加气 块) 一、编制说明 1.1 编制依据 序号 类别 名 称(项目自拟编号)规范如有更新须作相应更改) 1 《砌体结构工程施工质量验收规范》GB 50203-2011 2 《蒸压加气混凝土砌块》GB/T 11968-2006 3 4 《蒸压加气混凝土砌块、板材构造》13J 104 标准 《预拌砂浆应用技术规程》JGJ/T 223-2010 规范 5 《砌体现场检测技术标准》GB/T 50315-2012 6 《建筑施工安全检查标准》JGJ 59-2011 7 …… 8 **工程承包合同 9 相关 **工程施工图纸 10 文件 **工程施工组织设计 11 …… 1.2 编制人员 序号 编制人 职务 编制时间 1 张三 项目总工程师 2019.1.1 2 …… …… …… 1.3 发放范围 序号 单位 部门 1 公司/分公司 工程管理部、技术质量部、安全部…… 2 项目部 工程部、技术部、质量部、安全部、…… 3 …… …… 1 [工程名称] 砌体结构工程施工方案(项目自拟编号)加气 块) 二、工程概况 2.1 工程概况 项目 内容 由*层地下室、*栋高层组成,总建筑面积**m2 工程组成 1~ 单位工程 3、6、7、10、11、14 4、5、9、12# 15、16、19# 8、18#楼 13、21、22#楼 框剪 框剪 框剪 17.8 29.4 53.6 53.6/97.8/75.6 17/18F 6F 10F 17F 17/30/24F 14/15F 3F 7F 14F 14F/26F/20F 2.95m 2.9m 2.9m 3.15m 3.15m 户型情况 140 户型 115 户型 115 户型 260 户型 180 户型 其他情况 …… …… …… …… …… …… …… …… …… …… …… 楼 楼 框剪 框架 51/53.1 总层数 标准层层数 、17、20、23#楼 结构形式 建筑物 总高度(m)m) 标准层 层高(m)m) 2.2 设计简介 砌体及砂浆要求 部位 地下室人防区域 地下室非人防区 室内地坪以上部分外墙、内 墙、楼梯间和人流通道以及 卫生间墙体 墙体材料 蒸压加气混凝土砌块 200㎜厚 蒸压加气混凝土砌块 100、200㎜厚 蒸压加气混凝土砌块 100、150、200㎜厚 砖/砌块强度等级 砂浆强度等级 A5.0,B07 砌块干容重 M5 专用砌筑砂浆 ≤6.0kN/m³ A5.0,B07 砌块干容重 M5 专用砌筑砂浆 ≤6.0kN/m³ A5.0,B07 砌块干容重 M5 专用砌筑砂浆 ≤6.0kN/m³ 墙体 200 导墙、煤矸石多孔砖 墙体在室内地面上 200 高处至 地梁或地下室顶板埋土部 分、室内地坪以下墙体、阳 MU15 水泥砖 100、200㎜厚 台砖砌拦河以及天面女儿墙 砌体 2 MU15 M10 水泥砂浆 [工程名称] 砌体结构工程施工方案(项目自拟编号)加气 块) 非围护构件(m)如花池、台阶、 MU15 水泥砖 女儿墙和栏板等)、地下挡土 MU15 200㎜厚 砌体等 M10 水泥砂浆 砌体的施工质量控制等级为 B 级 三、施工部署 3.1 组织机构 3.1.1 组织机构图 根据工程特点,建立以项目经理为核心的管理层,全权组织、指挥、 协调现场施工,对工期、质量、安全、成本等进行严密综合组织管理。组 织机构图如下: 项目经理 项目总工程师 项目生产经理 项目安全总监 施 技 安 材 设 工 术 全 料 备 * 员 员 员 员 员 员 * 劳务公司/砌体班组 施工管理组织机构图 3.1.2 岗位职责 序号 职位 1 项目经理 2 项目总工程师 3 生产经理 4 质量工程师 职责(项目自拟编号)针对砌体工程施工) 全面负责砌体施工资源调度 负责砌体施工前方案编制,负责砌体施工过程中的安全技术交底, 组织砌体样板验收 负责砌体施工过程中的质量、安全、进度,材料、人力等资源的组 织,参与砌体样板验收 负责砌体施工过程检查,组织砌体工程自检 3 [工程名称] 砌体结构工程施工方案(项目自拟编号)加气 块) 5 安全工程师 6 施工技术员 负责砌体施工过程安全监管 负责现场施工管理,对质量、安全、材料及劳动力的一线管理和执 行。 …… …… 3.2 工程施工条件 序号 项 目 内容 (项目自拟编号

docx文档 23-砌体结构工程施工方案编制指南(加气块)

技术资料 > 施组方案 > 施工专项方案 > 文档预览
30 页 0 下载 335 浏览 0 评论 0 收藏 3.0分
温馨提示:如果当前文档出现乱码或未能正常浏览,请先下载原文档进行浏览。
23-砌体结构工程施工方案编制指南(加气块) 第 1 页 23-砌体结构工程施工方案编制指南(加气块) 第 2 页 23-砌体结构工程施工方案编制指南(加气块) 第 3 页 23-砌体结构工程施工方案编制指南(加气块) 第 4 页 23-砌体结构工程施工方案编制指南(加气块) 第 5 页
下载文档到电脑,方便使用
还有 25 页可预览,继续阅读
本文档由 热心网友 2021-10-05 21:35:34上传分享
给文档打分
您好可以输入 255 个字符
doc5的中文名是什么?( 答案:道客屋 )
评论列表
  • 暂时还没有评论,期待您的金玉良言